The flat roofing material must go up the wall a minimum of 12 or up the wall and over the top of the wall if the wall is less than 12 high.
Roof to wall connection detail.
For example wood roof to masonry wall pocket and ledger connections were used in residential masonry homes in the united states during the 1700s 1800s and 1900s and continue to perform satisfactorily.
Here is an attempt though maybe not a very good one to make the roof flashing serve also as a through the wall flashing with a tile roof.
Cad details document name pdf dwg download all cad construction details 37 1 mb 3 4 mb mc01 identification of roof areas 694 kb 167 kb mc01a single layer underlayment 678 kb 302 kb mc01b double layer underlayment 711 kb 322 kb mc02 vent pipe flashing 626 kb 349 kb mc03 valley.
Cold roof insulation between rafters wnapor barrier on warm side below orw sheatiiing roofing roofing 2 x 8 sleepers notched for vent aligned wi rafters flashing over rooang fascia sheatiiing 2 x 4 sleepers aligned w rafters provide.
Sip 122 beveled wall panelsip 122a beveled 2x blockingsip 122b beveled wedge blockingsip 122c gable endsip 122d plumb eave beveled wedge blockingsip 125 ceiling panel and trusssip 125a ceiling panels and raftersip 121d sip roof and wood ledgersip 121e sip roof and steel angle ledgersip 124 truss bearing on wall panelsip 124a truss bearing on wall panel.
Technical fact sheet no.
23 window and door installation home builder s guide to coastal construction page 2 of 3 figure 2 installation sequence for deck.
See fact sheet nos.
Performance of conventional roof systems and components including ceiling joist to rafter connections and roof framing to wall connections.
To view a cad detail you will need a cad design program or a cad viewer program.
Similarly residential builders may not be familiar with.
Pocket connection a pocket connection consists of framing the floor or roof system into a void in the masonry wall.
This detail is used when masonry continues above either as part of the wall or as a parapet the connection location and eccentricity is to be minimized.
When you locate the detail you want just click one of the four file format buttons to download it to your computer.
Cad details are available in dwg dwf dxf and pdf format.
Figure 1 roof wall ﬂashing detail.
Individual connections and connections within full scale roof systems were tested to quantify potential system effects.
And pocket connections are not however new to the building industry.